General information about 1.1 / 1.3 l engines Small displacement 1.1L engines can be installed on Golf and Jetta models (1043 cm 3 ) and 1.3 l (1272 cm 3 ), which are identical in design. The engine has a valve train with an...
Tool and equipment All fasteners on the engine are metric. The heads of the bolts can be both regular and with internal hexagons, therefore, to loosen them, you will need sets of ordinary wrenches...
Camshaft drive belt (toothed belt) Replacement 1. To replace the toothed belt, the alternator belt and toothed belt cover must be removed. 2. Loosen the mounting bolts and the alternator adjusting bar bolt, rotate...
Camshaft oil seal Replacement The camshaft seal can be replaced without removing the camshaft and cylinder head. 1. Remove the toothed belt as described earlier. Remove the sprocket mounting bolt...
Cylinder head Cylinder head bolts Two types of bolts can be used to attach the cylinder head, so when installing new parts such as the cylinder block, cylinder head and gasket, it is important...
Crankshaft seals Front oil seal (pulley side) - replacement The front crankshaft oil seal is easily replaced after removing the toothed belt. 1. Turn out a bolt of a pulley of a cranked shaft and...
Oil pump Removing 1. Remove the drain plug from the oil pan and drain the engine oil into a clean container. 2. Remove a gear belt as it is described earlier. 3. Remove the pulley bolt and...
Removal and installation of the engine Removing The engine is removed from the car along with the transmission, and then separated from it. It is not necessary to remove the hood, but it is recommended to do so for...
Engine repair Disassembly (pic. B:35 and B:36) 1. Loosen the alternator drive belt, remove the belt, then remove the alternator. 2. Remove the toothed belt. 3. Remove the back plate of the...
Exhaust system (exhaust system) Replacement Check the exhaust system periodically for corrosion and exhaust leaks. Golf, Jetta and Scirocco models have a three-section exhaust system mounted on rubber...