General information about automatic transmission On models with engines 1.5/1.6/1.8 l (except models with fuel injection system) a three-speed automatic transmission can be installed at the customer's choice (pic. K:15)....
Tool and equipment In addition to the basic set of tools described in the chapter " Basic rules for work ", to perform the operations described in this chapter, it is useful to have the following:...
Transmission tests in a braked state To evaluate the operation of the torque converter, tests can be carried out in a braked state: During the tests, it turns out at what maximum speed the engine can rotate the...
Selector lever cable Adjustment Proper adjustment of the selector cable is essential to the normal operation of the automatic transmission, so follow the instructions below carefully Loosen the clip...
Starter lock switch Adjustment If the starter lock switch setting is correct, the engine can only be started when the selector lever is in the "N" or "R". The switch, consisting of a moving contact...
Removal and installation of transmission Removing Parts that should be disconnected before removing the transmission are shown in fig. K:4. 1. Disconnect the wire "masses" from the battery. 2. Disconnect the speedometer...
Torque converter oil seal If oil leaks from the torque converter seal, the seal must be replaced. To do this, remove the transmission from the engine. Remove the torque converter from the housing without...