Carefully remove the strips from the holders.
If necessary, push the pin in the clip: remove the clip. True, the pin will disappear in the closed cavity and it will not be possible to get it.
Insert new clamps and drive plastic pins there, due to which the clamp is released.
Install plank.
If the bar is no longer held in the holder, try to shape it the way you want (it can be bent).
Installation of a decorative overlay
On better equipped models, the trim is inserted into the window seal before the glass is installed.
When installing a decorative strip, it is imperative to place a gasket to protect the paintwork
Lay the rubber seal against the glass.
Insert a wire with a diameter of 3 mm into the slot for the decorative trim.
At the point where the ends of the wire converge, you will begin to insert a decorative overlay.
Pull the wire out gradually and insert the overlay into the opening slot.
Before the decorative adjustment is fully inserted, put a lock on its ends.
Visitor comments