Unscrew the bolt of the safety sheet in the middle of the seat in front, at the pillar.
Pull out the sheet, for this the seat is slightly moved forward.
Models manufactured after August 1978: Move the seat forward.
In front, near the stand in the middle of the seat, unscrew the bolt, as shown in (photo below).
To the left of the guide (1) seat screwed in safety screw (2) with puck (3) and spherical nut (1)
Right: for removing the rear seat in the model "Golf" remove washer (5) from the locking pin Now you can move the locking support (6)
Remove the rear outer seat rail cover.
Slide the seat back and out.
Before reassembling, check whether the sliders on the seat supports and in the front in the middle are not damaged. Otherwise, the seat wobbles.
Back seat in the model'"Golf": fold forward.
On the right and on the left, remove one clip of the fixing support (racks).
Remove the stand from the locking pin.
In the model "Jetta": Unscrew one Phillips screw each at the front edge of the seat on the right and left.
Remove plastic covers.
From the bottom side, grasp the seat and pull up and forward.
Fold the rear seat back forward (in the model "Golf").
Disconnect the locking screws of the seat back hinges.
Seat back in model "Jetta": In the trunk, disengage the upper retaining clips while an assistant in the car pulls up the seatback.
When installing, make sure that all four clips engage in the boot bulkhead.
Visitor comments