Rear lamp in the model "Golf" Released July 1980 right - in the model "Jetta": 1 - fixing bracket; 2 - cover; 3 - lamp holder; 4 - nuts of the lamp housing; 5 - multi-pin connector; 6 - negative cable.
The taillights can be accessed from the trunk side.
In the model "Golf" release before July 1980 (see fig. top left): Swing the fixing clips of the cover to the side, remove the cover.
Move the fixing clips on both sides again: carefully pull out the metal support of the lamps.
In the model "Golf" release after August 1980, in the model "Jetta" (see fig. top right): slide the fixing clips of the lamp support on both sides: remove the lamp support.
Replacing incandescent lamps is carried out in the same way. Lightly press the lamp in the cartridge; turn left and pull out.
To replace the rear light glass, unscrew the 4 nuts.
When reassembling, make sure that the brown earth cable attached to the light housing is connected to the body again; otherwise, the operation of the lamps in the lantern will be disrupted.
Visitor comments