Description of the design of the turbocharger In a diesel engine, compared to a carburetor, a relatively long time is required for internal mixture formation in the swirl chamber and combustion chamber. The maximum speed of...
Removal and installation of a turbocharger Before replacing a supposedly defective turbocharger, it is necessary, just in case, to check: the start of the fuel pump supply, fuel supply to the pump, compression, air filter,...
Possible malfunctions in the turbocharger If the turbodiesel engine is running at a markedly lower power output, or if top speed is not reached, then a fault in the turbocharger may be the cause. In the table, we have...
Description of the design of the exhaust system At the exhaust system "hard life": tormented by corrosive acids inside, water splashes outside and high temperature, it must guide at a certain speed (for the best engine power)...
Checking the condition of the exhaust system suspension The exhaust system, which was used until July 1979, is rigidly connected to the exhaust pipe elbow and is connected to the gearbox using a bracket. Models built after August 1979...
Release System Update Repair of a rusted exhaust system in most cases is of little success. If the metal is rusted, then it is so weak that it is impossible to perform welding work. Although the...
Removing the exhaust system Fortunately, it is very rare for the front exhaust pipe, which is mounted right at the exhaust pipe elbow, to be damaged. During all work on the exhaust system, the machine must...
Removing the front exhaust pipe There are two types of fastening of the front exhaust pipe. Fastening of the front exhaust pipe for models after August 1979 1 and 2 - spring clips; 3 - sealing ring Models built...
Removing the exhaust pipe For connecting the exhaust pipe to the cylinder head, the same instructions apply as for the threaded connection between it and the front exhaust pipe. Without the use of a rust...