Engine technical data Engine type - four-cylinder, in-line, liquid-cooled, camshaft in the head. Ignition sequence - 1-3-4-2 (camshaft wheel side cylinder 1).
Engine housing 1. Check the surface of the cylinder liner for signs of friction, scratches, cracks or corrosion. For the elimination of small scratches, it is enough to treat the surfaces with a...
Crankcase bleed system The crankcase bleed system consists of an oil separator in the valve cover connected to the air filter with a rubber hose. The reduced pressure in the air filter causes gases to...
Oil sump If the engine is in the vehicle, the following operations must be carried out: A) Tighten the handbrake. Raise the front of the car and support it on stands. b) Remove the...
Flywheel — removal, repair and installation 1. Remove the clutch. 2. Block the flywheel using a lever or steel goniometer inserted into the ring gear teeth. 3. Unscrew the bolts and remove the flywheel from the crankshaft...
Engine Assembly General information 1. To ensure maximum strength with minimum care, the engine must not only be properly assembled, but we must also take care of cleanliness during assembly. All...
Starting the engine after repair and adjustment 1. After installing the engine in the car, you need to check if everything is connected correctly, if there are rags and tools in the engine chamber. 2. Pre-set the ignition...