Drive shafts: device The drive from the main gear is transferred to the wheels with the help of two drive axle shafts. A hinge is fixed at each end of the axle shaft. The inner hinge is bolted to the...
Drive shaft — replacement Removing 1. The drive joints are bolted to the drive flanges near the box with socket head bolts, the unscrewing of which requires the use of special bar splines (photo 7.1)....
Drive joints Removing and installing hinges 1. After removing the axle shaft from the vehicle, it can be disassembled for parts to check for wear. 2. Rubber boots, spring rings, thrust washers...
Disassembly of the outer hinge 9. To disassemble the hinge, you must first remove the balls, which are easily planted in the basket. Therefore, they can be pushed out without problems by inserting a screwdriver...
External Hinge Assembly 20. Assembly must begin by squeezing half of a special graphite grease with molybdenum additives out of the tube (those. 45 g) into the hinge body. 21. Insert the hub into the...
Installing the external hinge on the axle shaft 26. Install the rubber casing 3 and the clamping band 1 on the drive axle shaft 2 (pic. 7.3), taking care not to overstretch the casing. Pic. 7.3. External hinge included 1 -...
Internal hinge 30. Install the axle shaft in a vice. 31. Remove the spring ring 5, which secures the hinge 6 on the axle shaft 9 (pic. 7.1, photo 7.13). Pic. 7.1. Drive shaft assembly 1 - gasket...
Disassembly of the inner joint 37. Mark the position of the hub in relation to the basket and the hinge body (quick dry paint) (photo 7.17). 38. Rotate the hub and basket 90°in relation to the body, and then...
Mounting the inner hinge 42. Installation must begin with the installation of the hub in the basket (photo 7.22). 43. Insert the balls into the sockets of the basket (photo 7.19) 44. Install the basket...
Inner Hinge — gti Models 51. Act as in other models. Please note that there is a gasket between the drive flange and the hinge. This gasket needs to be replaced. Wipe the sealing surfaces of the hinge and...
Drive flange seal Replacement 1. Disconnect the inner joints from the drive flanges according to the description of point 2 and the note given below: A) In models 1.05 and 1.3 l, disconnecting the...