Fuel injection systems — general information Depending on the year of manufacture, engine displacement and some other factors (see table. 1) vehicles can be equipped with fuel injection systems - KT-Jetronic, Mono-Jetronic,...
Description of the Digijet injection system Digijet Ignition and Fuel Injection System (pic. 154) developed by WV and installed on engines with NZ and RC indices. It is equipped with an idle speed regulator and forced idle...
Possible malfunctions of injection systems Possible malfunctions of all injection systems described in this publication and their solutions are listed below. Before troubleshooting, you should exclude any errors when...
Fuel pump and filters Fuel pump replacement The procedure for replacing the fuel pump is simple and does not require much explanation. The pump is mounted on the head of the block and the air filter...
Fuel level sensor Removing the sensor Disconnect the battery. Remove the sensor cover, which is located under the lining of the luggage compartment. Disconnect the sensor connector. Disconnect the...
Inertial and vent valves Inertial valve Release valve 1 to remove it ( see fig. 157 ) in the filler neck of the fuel tank by moving it up. In the vertical position, the valve must pass gasoline, and when...
Exhaust manifold replacement Fastening of a final collector of the carburetor engine is shown in fig. 158. Based on this figure, the exhaust manifold can be removed and installed. Pay attention to the...