Camshaft drive — design description The design of engines with a displacement of 1.6 and 1.8 liters has much in common with the design of engines with a displacement of 1.3 liters. Therefore, in this section, only...
Removal and installation of a camshaft Removing Remove the air filter. Remove the top casing of a gear belt. Remove the cylinder head cover. Insert the crankshaft into the cylinder position. Attention! After that, do...
Valve clearance adjustment On vehicles that do not have hydraulic tappets, it is required to check or adjust the valves on a warm (coolant temperature approx. 35°C) engine. Clearance values are given below....
Removing camshafts (16V) Set the piston of the 1st cylinder to the TDC position. Remove the top part of a casing of a gear belt. Remove the block head cover. Loosen the toothed belt tensioner, remove the...
Removing the cylinder head (16V) Disconnect the wire «masses» from the battery. Drain the coolant while collecting it. Remove the upper part of the intake manifold. Disconnect the coolant hoses from the block...