Replacing drive shafts Loosen the drive shaft mounting nut with the wheel not suspended. This nut is over tightened. Raise the front of the car and install stands. It is not necessary to remove the...
Replacement of the internal constant velocity joint (SHRUS) On fig. 374-376 shows the drive shafts of various designs. The internal constant velocity joint cannot be repaired and, if damaged, must be replaced. Pic. 374. Right drive shaft...
Replacement of the outer constant velocity joint (SHRUS) As well as the internal, the external hinge is replaced only as an assembly. Remove the clamps from both ends of the rubber boot. Slide the cover from the hinge onto the shaft....
Replacing the anti-vibration weight The anti-vibration weight acts as a vibration damper and consists of two parts connected by pins. If the axle shaft is to be replaced, it is necessary to knock out the pin shown...
Four-wheel drive cars Models «Golf syncro» and «Rally Golf» have all-wheel drive. The drive circuit is shown in fig. 382. Pic. 382. Scheme of transmission of all-wheel drive vehicles: 1 - engine; 2 -...