Technical parameters of electrical equipment Accumulator battery Voltage - 12 V, case "negative" Capacity - 45 or 63 Ah Charged state: fully discharged - Specific gravity 1,12,16°Baume fully charged - Specific gravity...
Electrical equipment. general information The electrical equipment of the car operates at a voltage of 12 V. The current to the body is carried out through the negative terminal of the battery. The battery is located in...
Accumulator battery The built-in 12-volt battery has six battery cells. consisting of positive and negative plates immersed in a solution of sulfuric acid. The task of the battery is to generate...
Checking the battery acid level. The battery is filled with sulfuric acid diluted with distilled water Since water can evaporate, the acid level should be checked whenever possible and topped up with...
Precautions when working with the charger Before carrying out any work on the charger, be sure to remember the graying precautions. Never disconnect the battery or voltage regulator while the engine is running and the...
Checking the built-in generator During normal operation of the vehicle alternator, the charging control lamp should not light. If it lights up, then there is a malfunction in it or the voltage regulator. First...
Dismantling and installation of the alternator Disconnect the chassis cable from the battery. Unplug the cable plug from the back of the car alternator. Pull the wire out of the disconnected clamp. Loosen the V-belt tensioner,...
Automotive Generator Repair «Bosch» Disassembly Unscrew the nut from the rotor shaft and pull the belt pulley, fan and spacer from the shaft. During dismantling, the shaft can be supported by winding the old V-belt...
Starter In the model «Golf» company starter installed «Bosch», matched to the engine power. To control the operation of the starter at maximum battery voltage, you need to connect the...
Dismantling and installation of the starter Disconnect the chassis cable from the battery. Place the front of the car on jack stands. Disconnect from the generator and from the ignition switch - starter both cable bundles...
Disassembly and assembly of the starter 1 - starter bushing 2 - starter screw 3 - drive bearing shield 4 - small parts 5 - switch with solenoid drive 6 - spring washer 7 - nut, 8 Nm 8 - screw 9 - single track lever...
Dismantling and installation of an incandescent lamp 1 - headlight 2 - servomotor for adjusting the range of lighting 3 - parking light bulb holder 4 - headlight lamp 5 - fixing clip 6 - cap 7 - parking light lamp On the side of the...
Dismantling and installation of headlights After dismantling the grille, unplug the multiple plug from the headlight bulb on the inside of the engine section and remove the screws. Pull the headlight completely towards you...
Headlight adjustment The headlight adjustment device is located on the inside of the engine section. Two adjustment wheels can be seen on the back of the headlight, I adjust them. however, from the...
Fog lights 1Fog lights are built into the car's bumper below the headlights. To remove the fog lamp, remove the towing eye cover and remove both Phillips screws 1. Remove from the bumper and...
Front turn signal light In vehicles without fog lamps, only a turn signal with a flashing light is inserted into the bumper. To dismantle it, you must first remove the towing eye cover from the bumper by...
Back light 1 - lamp cover 2 - seal 3 - incandescent lamp, reversing light, 21 W 4 - incandescent lamp, direction indicator, 21 W 5 - lamp socket 6 - incandescent lamp, rear light, 110 W 7 -...