Ignition system. General information The ignition system works in cooperation with the injection system, namely: all sensors and probes that are intended for the ignition system also affect the ignition system, and...
Safety precautions To prevent electric shock to a person, and also not to damage the ignition system, the following rules must be observed during all work. Do not disconnect the ignition cable or...
Distributor. General information The ignition distributor is designed to supply the ignition current in the correct sequence (1-5-3-6-2-4) and at the right time (ignition point) to the correct spark plugs. The...
Maintenance of the ignition distributor It is necessary to clean the ignition distributor cap inside and out at regular intervals to remove carbon residue, dust and moisture. It is also necessary to clean the...
Removal and installation of the distributor of ignition Unscrew the cable guides to the spark plugs on the top side of the cylinder head. They are attached as shown in Fig. and must rise in the direction of the arrows after the spark...
Ignition distributor repair Modern ignition distributors can only be repaired to a certain extent, and in most cases they must be replaced with new ones. At the moment, no recommendations for the repair of...
Setting the ignition timing The ignition timing is controlled electronically in conjunction with the fuel injection system and so that the needs of the engine are met under all other conditions. Although the...
Spark plug The spark plugs have a thread diameter of 14 mm. Special spark plugs are recommended and are commercially available under part number 101 000 025 AA. The marking of these candles...