Removal and installation of a rack of a back door Elements of fastening of a back door 1 - back door; 2 - inner upholstery of the door; 3 - emphasis; 4 - stand. Be sure to hold the tailgate open before removing the strut. When...
Tailgate/Tailgate Adjustment The boot lid/tailgate must be installed in such a way that, when closed, the gap around the bootlid/tailgate is the same throughout its entire length, and when closed, the...
Removal and installation of the lock of a back door Rear door lock details 1 - safety bracket; 2 - handle; 3 - a bolt of fastening of the executive engine of the lock with the central control; 4 - executive engine of the lock with...
Removal and installation of a door Fastening elements of the front door 1 - door; 2 - external handle for opening the door with a support; 3 - body of the lock cylinder; 4 - plug; 5 - bolt, 18 Nm; 6 - door lock...
Removal and installation of interior door trim This subsection describes how to remove the driver's door interior trim. The interior trim of the rear doors is removed in the same way as the front. Removing 1. Switch off...
Removal and installation of the internal door lock button Removing Release the button lock by turning it 180°clockwise or counterclockwise and pulling up to remove the button. Installation 1. Install the door lock button on the rod with...
Removal and installation of door glass Elements for fastening glass and front door bracket 1 - glass seal; 2 - front door; 3 - lower inner glass seal; 4 - bolt, 20 Nm; 5 - door bracket. The window regulator is an...
Removal and installation of an arm of a door The door lock, power window and loudspeaker are mounted on the door bracket. When a power window regulator needs to be replaced, it must be replaced along with the bracket....
Removal and installation of the lock cylinder housing Removing 1. Open the front door and remove the protective cap (3) from the bolt located near the front door lock cylinder (1 - lock cylinder mounting bolt, 2 - lock mounting...
Removal and installation of the door lock The door lock, power window and loudspeaker are mounted on the same door bracket. Removing the door lock can only be done together with the bracket. Removing 1. The door bracket...
Central locking system The location of the control units of the central locking system on the car 1, 3, 8, 10 - control units in the doors; 2, 4, 7, 9 - actuators integrated into the door locks; 3, 8 -...
Hatch drive The main differences by which you can determine the manufacturer of the hatch 1 - firm hatch " Webasto"; 2 - firm hatch "Rockwell"; 3 - hatch fairing base Manufacturers sunroof...
Removal and installation of fairings of the hatch Removing 1. Open the sunroof fully. 2. Press the bottom of the fairing (1) from both sides and simultaneously pull it towards the center of the car, as a result of which the...
Removal and installation of a sun-protection blind Removing 1. Remove the sunroof glass panel. 2. Slide the sunshade back. 3. Unscrew the left and right front screws of the sun shield (1) (the location of the panel fastening screw...
Checking the parallel movement of the sunroof Checking the parallelism of the movement of the hatch Arrow - installation mark. 1 - setting lever; 2 - backstage control; a - size Examination 1. Remove the glass hatch cover. 2....