Rear door lock details
- 1 - safety bracket;
- 2 - handle;
- 3 - a bolt of fastening of the executive engine of the lock with the central control;
- 4 - executive engine of the lock with central control;
- 5 - thrust;
- 6 - Torx screw;
- 7 - control rod;
- 8 - body of the lock cylinder;
- 9 - lock;
- 10 - bolt with a spherical countersunk head, 20 Nm;
- 11 - lever
Removing
1. Remove the bottom tailgate trim.
2. Remove the pull from the handle (5), safety bracket (1) and lock cylinder body.
3. Disconnect the electrical connector from the luggage compartment light.
4. If necessary, disconnect the spring clip of the control rod of the central lock.
5. Unscrew the Torx screws and remove the handle.
6. Disconnect the drive rod spring retainer (7), unscrew the bolts (10) and remove the lock from the rear door.
Installation
1. Install the lock and secure it with bolts.
2. Supporting lever (11), install the control rod on it (7).
3. Further installation is carried out in the reverse order of removal.
Visitor comments