Removing
1. Pull the jet by hand together with cover 1 as far as it will go out of the bumper (see illustration).
2. Release the cover from the fastening on the jet (see arrows in illustration 14.1).
3. Slightly lift the latch (see arrow in illustration) and remove jet 1 from housing 2.
Installation
4. Install the jet in the body and fix it.
5. Install and secure the jet cover.
6. Slide the landing housing with jet into the bumper.
7. Make sure the jet fits snugly into the bumper and the jet cover closes well. If necessary, sweep the jet even deeper into the bumper.
Attention! An excessively deep-set jet can cause deformation of the cover and bumper.
8. Check the operation of the headlight washer.
Bleeding the headlight washer
9. Pour washing liquid into the washer reservoir.
10. Start the engine and turn on the low beam headlights.
11. Turn on the headlight washer by pulling the washer switch five times and holding the switch pressed for the fifth time for three seconds.
Disconnecting the washer fluid hoses
The washer fluid hoses on Golf/Touran vehicles can be connected to the pump and jets in different ways.
12. Raise latch 1 by approximately one millimeter (see arrow A in the illustration) and disconnect the hose. When connecting the hose, put it on and press on the retainer.
13. Rotate retaining ring 2 by 90° (see arrow B in illustration 14.12) and disconnect the hose. When connecting, put on the hose and turn the retaining ring until it locks.
Visitor comments