2. Disconnect the pipes of the exhaust system, fixed in the suspension support on the gearbox and covered with a heat-reflecting shield. Remove the heat shield as well.
3. Unscrew the four nuts 9 (see illustration) and remove the transmission control mechanism.
2.3. Unscrew four nuts 9 and remove the gearbox control mechanism
1 - cover and gear lever handle
2 - selector mechanism with lever
3 - a bolt with a spring. Tightening torque 3 Nm
4 - pin
5 - locking plate
6 - nut. 4 pcs Tightening torque 9 Nm
7 - gearbox control lever housing (with seal)
8 - transmission control lever cable
9 - nut with washer, 4 pcs. Tightening torque 8 Nm
The installation of the mechanism is carried out in the reverse order. After installation, adjust the transmission control lever cable.
Visitor comments