Rear Suspension Specifications The rear suspension is semi-independent, linkage, with an elastic connecting cross member, with trailing arms welded to the cross member, with hydraulic telescopic shock absorbers...
Rear wheel specifications Rear wheel alignment The alignment angles of the rear wheels on an equipped vehicle with normal tire pressure and in the absence of excessive play in the rear suspension units...
Tightening torques of the main threaded connections, kgf.m Nut of fastening of the top end of the shock-absorber: 2,0. Nut of fastening of the lower end of the shock absorber: 6.0. Nut of a bolt of fastening of an arm of a beam to a body:...
Removal and installation of a back suspension bracket Hang the rear of the car and remove the wheels. Loosen the parking brake cable and disconnect it Disconnect it from the equalizer 1 (see picture). Rear suspension: 1 - cable...
Replacing the silent blocks of the rear suspension beam The rear suspension beam silent blocks are replaced using the VW 3111 special tool kit. Press the outer half of the silent block out of the beam using puller 3111, bracket 2 (see...
Removal and installation of naves of back wheels Remove rear wheel. Remove hub cap, cotter pin 1 (see photo) and toothed stop 2. Loosen the hex nut and remove the lock washer 3. Insert a screwdriver into the threaded hole for...
Replacing wheel bearings Use a copper mandrel to press out the bearing outer rings. The outer rings of new bearings should be pressed in using a VW 432 guide bush and a VW 411 mandrel.
Adjustment of a backlash in bearings of naves of back wheels Remove rear wheel. Remove the hub cap, cotter pin and toothed stopper. Set the hub bearing clearance by firmly tightening the hub hex nut while rotating the brake drum. Slightly...