Loosen the parking brake cable and disconnect it Disconnect it from the equalizer 1 (see picture).
Rear suspension:
1 - cable equalizer of the parking brake system;
2 — brake hoses;
3 - rear suspension beam mounting bracket.
Detach brake hoses 2 from rear suspension carrier.
Unscrew the nuts of the bolts securing the brackets 3 of the rear suspension beam to the body, leaving one nut on each bracket.
Loosen the clamp bolts for the pipes of the exhaust system.
Place a jack under the rear suspension and lower the rear of the car onto it.
Unscrew the nuts securing the upper ends of the shock absorbers.
Unscrew the two remaining nuts securing the rear suspension beam brackets to the body.
Slowly raise the rear of the vehicle.
Remove the rear suspension beam assembly with shock absorbers and springs.
Installing the rear suspension is done in the reverse order of removal, taking into account the following:
- brackets for fastening the rear suspension beam to the body must be located at an angle of 17±1°relative to the beam;
- observe the tightening torques of the screwed connections.
Rear Suspension Details:
1 — the top basic plug the shock-absorber;
2 — the lower basic plug of the shock-absorber;
3 - compression stroke buffer;
4 - cap;
5 - suspension spring;
6 - shock absorber;
7 - rear suspension beam;
8 - axle of the wheel hub;
9 - shield of the brake mechanism;
10 - stuffing box;
11, 13 - hub bearings;
12 - brake drum;
14 - castellated hub nut
Visitor comments