Disassembly
Remove the steering gear as described above.
Remove the spool housing and drive gear.
Remove the rack stop cover.
Remove the set of rack stop parts.
Remove the plug from the left side of the steering gear housing and remove the O-ring.
Remove the protective cover clamp.
Remove protective cover.
Remove the steering rack.
To remove the rack seal, perform the following operations:
- remove the ring with teeth;
- remove the retaining ring;
- press the rack oil seal out of the steering gear housing using a puller with an internal grip (e.g. Kukko 21/3);
- to install the rail gland, use the mandrel supplied with the gland kit;
- Install retaining ring and new toothed ring.
The assembly of the steering mechanism is carried out in the reverse order of disassembly. At the same time, pay attention to the correct position of the rail stop, the groove of which must be directed towards the spool body (see photo), and observe the tightening torques of the screw connections.
Install steering gear.
Visitor comments