Removing
Remove the wheel drive shaft as above.
Remove retaining ring.
Remove the clamp and protective cover.
Press the outer cap off the shaft with a mandrel.
Using a press and a mandrel, press the hinge out of the cap.
Installation
Install the Belleville washer with the concave side towards the hinge.
Put 90 g of bearing grease into the joint.
Put a protective cover on the wheel drive shaft.
Press the hinge onto the shaft until it stops with a press.
Install retaining ring.
Press on the outer cap of the hinge.
Push the protective cover into place and secure it with a clamp.
Install the wheel drive shaft to the vehicle.
Front wheel drive shaft details:
1 - wheel drive shaft;
2 - internal hinge;
3 - outer hinge.
Visitor comments