Design and specifications The hydromechanical gearbox consists of an automatic three-speed gearbox and a torque converter. It is integrated with the differential and final drive and is located behind the...
Gearbox Specifications The automatic transmission consists of two planetary gears controlled by three oil bath multi-plate clutches and a piston actuated band brake. The control high oil pressure acting...
Tightening torques for main threaded connections, kgf.m Bolt of fastening of a transmission to the block of the engine: 5,5. Nut of fastening of an arm of a suspension bracket to a transmission: 4,0. Bolt of fastening of a shaft of a...
Removal and installation of an automatic transmission Removal of an automatic transmission is made from below the car using the elevator. Removing Place the car on a lift. Disconnect the wire from the negative battery terminal....
Torque converter The impeller of the torque converter is connected to the flywheel of the crankshaft. The shaft of the turbine wheel is connected to the shaft of the gearbox, which is connected to...
Torque converter test The design of the torque converter is non-separable and cannot be repaired. By external examination, determine the condition of the hub and, above all, the oil seal. Check the...
Gearbox control mechanism Throttle cable adjustment As a result of this adjustment, the throttle should be in the closed position with the accelerator pedal released, and the gearshift control should be in...