Variant up to 9/93
- 1 - lining
Before removing, remove the inner lining of the rear door. Unscrew the license plate holder from the inside of the rear door. On the outside of the rear door, remove 1 Phillips head screw. After that, remove the lining by moving obliquely downwards. To install, insert trim with centering pin -4- into rear door and press down
- 2 - sleeve
- 3 - cross head screw
Access from the inside of the rear door.
- 4 - centering pin
- 5 - insert
- 6 - clamp
Embedded in cladding.
- 7 - insert nut
- 8 - protective film
Film installation see cross section.
Visitor comments