General information about the heating system 1 - drainage casing 2 - suction pipe 3 - sealing gasket 4 - intermediate element To replace, remove the instrument panel and heating system. 5 - heat exchanger 6 - air distributor...
Removal and installation of the suction pipe Removing Remove the drainage cover in the engine compartment. Remove bolt -5-. Remove suction pipe -4- together with retaining element -2-. 1 - clamping spring. If necessary,...
Check, removal and installation of the heater fan Removing Disconnect the battery ground wire. Remove the suction pipe. In the installed state, check the ease of movement of the fan wheel. Remove the lower cover in the upper part...
Removal and installation of the heating control unit 1 - control unit With heater fan switch. 2 - lamp To illuminate the heating control panel. 3 - lighting wire 4 - cover Removing Remove center console. If necessary, remove the...
Removal and installation of the blower Removing Turn swivel unit -2- vertically -arrow- and press down. Blower housing -1- Unscrew and pull out. Installation Insert blower housing and screw on.
Compressor V-Belt Tension Vehicles with 4-cylinder engine up to 9/93 Note: In vehicles with other engines, the compressor is driven by a wide V-ribbed belt, see chapter « Engine ». The V-belt is correctly...
Removing and installing the dust and pollen filter From 1/92, VW PASSAT cars are equipped with dust and pollen filters at the request of the owner. The filter element must be replaced every 15,000 km. The filter can also be...