Main headlight and turn signal lamp 1 - plug socket For the mass at the reflector. 2 - mounting thread 3 - sealing gasket 4 - headlight housing left 5 - sealing gasket 6 - cover With bayonet fastening, pay attention...
Replacing incandescent bulbs in cars before 9/93 Before replacing a light bulb, switch off the respective current consumer. Attention: Do not grasp the lamp by the glass with bare fingers. Fingerprints, due to the heat generated...
Removal and installation of a reflector Car models up to 9/93 Removing Remove main headlight. Use a narrow screwdriver to carefully pry the retaining clips away from the diffuser. Remove the diffuser from the headlight...
Removal and installation of fog lights Car models up to 9/93 Removing Remove bezel -2-. To do this, use a narrow screwdriver to carefully remove the expansion rivet -4- from the clamp -3-. Remove clip -3- and remove...
Headlight adjustment Proper headlight adjustment is essential for road safety. Fine adjustment of the headlights is only possible with a special adjustment device. Therefore, this chapter only...
Rear light device Note: lamp positions changed from 10/93, picture shows early model car. 1 - body 2 - M5 nut with washer 3 - incandescent side light, 12 V, 5 W; only for the Limousine model. 4 -...
Replacing light bulbs in cars since 10/93 Turn off the corresponding lamp. Open the engine hood. Headlight bulbs Remove the intake air cover to gain access to the back of the headlight. Compress the spring plates and...
Replacing incandescent interior lighting Carefully press out lens -A-. To do this, insert a knife into the gap between the diffuser and the housing from the side. Take out the lamp. Insert a new lamp, press the diffuser...
Replacing taillight bulbs Open back door. Tailgate lamps Variant: Loosen the cover on the inner door trim. Squeeze the left and right spring plates to the center of the lamp (in the direction of the...
Replacing the license plate light bulb Open back door. Loosen the lamp diffuser (arrows). Pull out the entire lantern and remove the defective lamp. Insert a new lamp. Attach diffuser to lamp holder. In this case, the...