Setting the backrest
The backrest can be installed in one of two positions.
Pull the lever to change the backrest position (A) forward.
Adjust the backrest to the desired position and secure. When changing the position of the backrest, the height of its upper edge changes by 50mm.
Back with lock
If the lock lever does not move forward, you need to unlock the lock (IN) main key.
Folding the backrest forward
pull the lever (A) forward and lean back.
The head restraints can still remain if they are fully pushed into the backrest, and the front seat is not moved far back.
Attention: The backrest of the rear seat must be locked in one of two positions so that it does not fold forward during sudden braking.
Folding the seat cushion
The split rear seats can be fully folded down. For this:
Remove the head restraints.
Pull out the seat cushion by the loop (WITH) and lean forward.
Press the backrest release lever (A) and lower the seatback until it clicks. The headrests can be fixed in the corresponding holes in the seat cushion (D).
Before installing the seat cushion in place, it is recommended to fasten all seat belt buckles; when installing, you only need to hold the middle one at the top with your hand (belt) belt.
Visitor comments