Vehicle exhaust system Volkswagen Passat B3

Exhaust gas exhaust system
The exhaust system of a gasoline engine consists of a front exhaust pipe, a preliminary, middle and subsequent mufflers. In vehicles with a catalytic converter, an exhaust gas...

Removal and installation of system of release of the fulfilled gases
Removing Raise the car. Spray all bolts and nuts of the exhaust system with a rust remover. Leave the agent on the surfaces of the parts for some time to show its effect. Remove...

Replacing pressure springs
Only when using expansion wedges If it is necessary to loosen the removed clamping spring (for attaching the front exhaust pipe to the exhaust pipe) or unclamp to install a new...

Removal and installation of the subsequent muffler
Removing Raise the car, see section « Vehicle lifting ». Nut yoke type «terminal» spray rust remover between the middle and following mufflers. Leave the product for a while to...

Removal and installation of the oxygen sensor
The oxygen sensor is used to regulate the composition of exhaust gases and is installed on vehicles with an adjustable catalyst. It is screwed into the catalyst housing or into...

Vehicles with catalytic converter
Depending on the model and version, VW PASSAT vehicles are equipped with one catalytic converter. Gasoline engines with a catalyst must only run on unleaded gasoline. In the...

Car Catalyst Handling
In order to avoid damage to the oxygen sensor and catalytic converter, the following instructions must be observed without fail: Petrol engines Be sure to use unleaded gasoline...

Visual check of system of release of the fulfilled gases
Raise the car. Check the tightness of the clamps. Inspect the exhaust system with a light for holes, rusted parts, and worn areas. Replace noisy exhaust pipes. Check the rubber...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Passat B6 Passat B5 Passat B4

Passat B3 Passat B2