- 1 - VEZ control unit
Right under the water cover.
- 2 - connecting plug
- 3 - vacuum pipeline
- 4 - throttle angle sensor
- 5 - connecting plug
- 6 - switch TSZ-H
Right under the water cover.
- 7 - connection to ground
On the camshaft bearing cap.
- 8 - spark plug, 20 Nm
- 9 - spark plug tip
- 10 - high voltage wire
- 11 - ignition coil
- 12 - ground wire
To the VEZ control unit.
- 13 - terminal 1 (-)
- 14 - terminal 4
- 15 - terminal 15 (+)
- 16 - ground wire to the TSZ-H switch
- 17 - sealing ring
- 18 - fastening bolt, 10 Nm
- 19 - ignition distributor
- 20 - dust cap
- 21 - distributor slider
- 22 - carbon brush with spring
- 23 — a cover of the distributor of ignition
Clean before installation.
- 24 - cap with noise suppression resistor
- 25 - tip with noise suppression resistor
- 26 - sealing ring
Always replace.
- 27 - temperature sensor
- 28 - connecting plug
Visitor comments