Removing
Raise the car.
Drain the engine oil, then install the drain plug with a new gasket and tighten to 30 Nm.
Unscrew and remove oil pan.
Attention: To loosen the two side bolts on the gearbox, you need an extended socket, eg VW 3185 or HAZET 986 Lg-5.
Installation
Replace the oil pan seal after removing the old seal.
Attention: Do not glue the gasket. Pay attention to the correct position of the gasket in relation to the holes.
Screw on the oil pan evenly, tightening the bolts to a torque of 20 Nm.
Fill with oil.
After a test drive, check the oil pan seal for oil leakage, if necessary tighten the oil pan bolts slightly.
Visitor comments