Features of the engine ignition system device «EZ» Vehicles with engine «EZ» manufactured until 1993 are equipped with an electronic non-contact ignition system. It consists of a distribution sensor with a built-in electronic...
Removal and installation of the sensor-distributor ignition To remove, disconnect the wires from the battery. Disconnect all high-voltage wires from the sensor-distributor. Remove the clutch housing manhole cover. Set the piston of the 1st...
Setting the ignition timing with a stroboscope Start and warm up the engine to normal operating temperature (oil temperature not less than 60°C), then stop it. Disconnect the vacuum hose from the sensor-distributor. Connect a...
Engine ignition system «RP» release before 1993 The ignition system is similar in design to the engine ignition system «EZ» and differs in the characteristics of some nodes, which are given below. Bosch ignition distributor 0...