Removing
Removing the selector lever trim
- 1 - clamps,
- 2 - decorative overlay,
- 3 - electrical connector
1. Remove the center console.
2. Remove the handle from the selector lever. To do this, move down the sleeve under the handle until it stops, remove the button and, pulling up, remove the handle from the selector lever.
3. Release two latches (1) on each side of the decorative trim (2) selector lever and pull up to remove the selector lever trim.
4. Disconnect from a decorative overlay of the selector an electric socket (3).
Installation
1. Installation is made in sequence, return to removal.
2. Install the selector lever knob. To do this, set the selector lever to position 2 and pull out the side button to the stop and, while pressing, place the handle on the lever.
3. Install the center console.
Visitor comments