Location of the electrical connector on the inside door handle
- 1 - connector lock,
- 2 - electrical connector,
- The arrow indicates the direction of pulling out the electrical connector retainer.
Removing
Removal of draft of the internal handle of opening of a door
- 1 - thrust,
- 2 - thrust guide,
- 3, 4 - electrical connectors
This subsection describes how to remove the driver's door interior trim. The interior trim of the rear doors is removed in the same way as the front.
1. Switch off ignition and remove a wire of weight from the accumulator.
2. Insert the blade of a thin screwdriver between the handle cover and the recessed handle cover and move the handle cover towards the door. Use a screwdriver with a very thin blade to avoid damaging the plastic trim on the handle and the door handle.
3. Using a screwdriver inserted under the edge of the notch handle, pry the notch handle out of the door interior trim. Do not remove the inner door handle by the notch, as there is a lintel of the door interior trim underneath it.
4. Pull the electrical connector retainer out of the connector and disconnect the electrical connector from the inside door handle, see fig. The location of the electrical connector on the inside door handle.
5. Through the hole after removing the door handle, unscrew the three screws.
6. Remove the screws securing the bottom of the interior door trim.
7. Unscrew and remove the door lock button.
8. Using the VW-3392 tool or your own flat fork tool, separate the door trim from the door.
9. Lifting up the door upholstery, release the upper part of the door upholstery from the window opening.
10. Moving back draft of opening of a door, take it from directing and disconnect from the internal handle of opening of a door, see fig. Removing the pull rod of the inner door opening handle.
11. Remove the door trim.
12. Remove the lower inner glass seal from the door upholstery and install it in the window opening.
Installation
1. Before installing the door upholstery, check the condition of the upholstery clips and, if necessary, replace the damaged clips. Install the clips into the hole in the door trim.
2. Installation of an upholstery of a door is made in sequence, return to removal.
3. Connect ground wire to battery.
Visitor comments