Pic. 4.34. Nut of a carving connection of the top cross-section lever with a subframe
Loosen the nut a of the threaded connection of the upper transverse arm with the subframe (pic. 4.34).
Adjust the camber by turning the hex of the eccentric bolt.
Note: The maximum adjustment range is 90°to the left or right of the center position.
Tighten nut A (pic. 4.34).
To do this, use a spanner wrench.
When using a ring wrench, tighten the nut to 65 Nm.
Pic. 4.35. Nut tightening
After tightening the nut a (pic. 4.35) recheck the camber value.
Visitor comments