Checking the headlight alignment using the alignment screen without adjustment line 15°

Main headlights

Check whether the horizontal border of light and shadow touches line 1 on the screen surface when the low beam is on and whether the bend point 2 passes between the left horizontal part and the right ascending part of the border of light and shadow vertically through the central mark 3. The bright core of the light beam should be on the right from the vertical line (pic. 7.67).

Note: To easily determine the bending point 2, close and reopen the left half of the headlight several times (in relation to the direction of travel). In conclusion, check the dipped beam again.

Note: When the dipped beam is correctly adjusted, the center of the high beam should be at center mark 3.

For the previously used alignment screen with 15°adjustment line, the same adjustment options apply as for the new screen. to avoid incorrect adjustment, the 15°adjustment line should no longer be considered (pic. 7.68).

Fog lights

Check if the upper border of the light and shadow touches the adjustment line and that it runs horizontally across the entire width of the screen (pic. 7.69).

Other additional lights

In conclusion, it is necessary to check and adjust the installed additional headlights of other systems in accordance with the standards in force for them.