Removing
Remove the support bracket, Passat.
Remove the support bracket, Eos.
Pic. 3.15. Removing the clutch pedal
Using pliers, unhook the master cylinder linkage mount (pic. 3.15).
Insert spacer A between the clutch pedal and stop and press the clutch pedal against the spacer.
The length of the spacer is approximately 40 mm (e.g. 1/2 socket wrench)
Pic. 3.18. Removing the master cylinder from the bracket
Unlock safety bracket B and pull master cylinder out of support bracket 1 and 2 (pic. 3.18).
Installation
Move the clutch pedal all the way to neutral.
Pic. 3.16. Installation of fastening on draft of a drive of the main cylinder
Establish fastening 2 on draft of a drive 1 of the main cylinder (pic. 3.16).
Insert spacer A between the clutch pedal and stop and press the clutch pedal against the spacer.
The length of the spacer is approximately 40 mm (e.g. 1/2 socket wrench).
Fix the master cylinder to the support bracket 1 and 2 (pic. 3.18).
Pic. 3.19. Installing the drive rod in the mount
Press the drive rod 1 for the master cylinder in the direction of the arrow until you hear an audible click of the fastener 2 in the clutch pedal (pic. 3.19).
Install the support bracket.
Visitor comments