Removing the flange shaft seal Remove noise insulation. Substitute the drain pan. Mark the position of the nuts with which the lower suspension arm is bolted to the suspension strut. During reassembly, this...
Fitting the flanged shaft seal Installation is carried out in the reverse order. In doing so, pay attention to the following. Lubricate the outer circumference and sealing lip of the sealing ring with ATF....
Removal and installation of a power shaft Pic. 3.97. Drive shaft components: 1 - SHRUS external; 2 – a bolt with a six-sided head; 3 - drive shaft; 4 - collar; 5 - CV joint boot; 6 - clamp; 7 - disc spring; 8 - thrust...
Removing the outer CV joint Clamp the drive shaft in a vise with jaws to prevent damage. Pull back the boot. Pic. 3.99. Removing the outer CV joint Remove the CV joint from the drive shaft using the barb A...
Checking the outer CV joint The pivot must be disassembled to change the grease if heavily soiled, and to check the ball contact surfaces for wear and pitting. Removing Before disassembly, mark the location...
Checking the inner CV joint Removing The pivot must be disassembled to change the grease if heavily soiled, and to check the ball contact surfaces for wear and pitting. Rotate the cage and separator. Pic....
Checking the performance of the SHRUS Pic. 3.109. The correct position of the Belleville spring of the inner CV joint: 1 - Belleville spring Pic. 3.110. The correct position of the Belleville spring and thrust washer...