Removing
Fastening clip: using a screwdriver or HAZET 799-4 pliers, pull out the clip and remove the cladding.
Clip/spring clip on rear side of trim: Press trim at clip holders until clip -A- or spring clip -B- comes out of opening in bodywork.
Installation
Before installing, check the spacer clips for damage and replace if necessary. If necessary, check the correct position of the clips in the lining.
Fastening clip: attach the cladding, insert the clip into the hole and press.
Clamp/spring clamp: Attach the lining so that the clamps fit into the hole. Fasten the clips in the holes by firmly pressing the lining.
Visitor comments