3-door model
Removing
Remove sill trim, see relevant chapter below.
Remove the cushion and backrest of the rear seat, see relevant chapter below.
Pull side trim -1- at clips -2- away from side wall. In this case, release the lining in the direction from the bottom up.
Pull the side trim out from under the door seal.
First pull the side trim inwards -arrow A- and then remove it upwards -arrow B-.
Installation
Check the clamps for damage and correct positioning on the cladding, replace the clamps if necessary.
Installation is carried out in reverse order. When doing this, ensure that the door seal is positioned over the edge of the trim.
Visitor comments