Steering/ Inflatable airbag The steering system primarily consists of the steering wheel, steering column, rack and pinion steering gear and steering rods. The steering wheel is screwed to the steering...
Safety precautions when working with an inflatable airbag The airbag system consists of a collision sensor, a gas generator and an airbag assembly. The command to inflate the airbag is carried out based on an electrical signal. The...
Removing and installing the POLO airbag assembly Removing Read and follow the safety instructions for working with the airbag. First, disconnect the ground wire from the battery (-), and then the positive wire (+). Attention:...
Removal and installation of a steering wheel Removing Turn the wheels of the car to the straight ahead position. Remove the airbag assembly -4- following the safety instructions, see relevant section above. Unplug connector...
Removal and installation of a tip of steering draft Removing Note: Removal of the tie rod assembly is possible only after dismantling the steering mechanism (at the service station). Check the clearance in the steering rods: raise...
Steering gear/tie rods/bellows/wiring diagram Electro-hydraulic power steering 1 - tie rod end right Remove grease from ball joint taper pin before installation. 2 - locknut, 50 Nm 3 — a tape spring collar Removal and...