Caution: Do not move the vehicle until all passengers have taken their seats. Do not allow passengers to sit on the folded rear seat, on the floor of the luggage compartment, or on things. A passenger who is not seated properly in the passenger compartment and is not wearing a seat belt can be seriously injured in the event of sudden braking or in an accident.
When the vehicle is moving, do not allow passengers to get up and change places on the move - they can be seriously injured in the event of emergency braking or in an accident.
The front seats can be adjusted in a wide range - you can adjust the longitudinal position of the seat, the height of the pillow, the backrest tilt, the height and inclination of the head restraints. The adjustment of the driver's seat is especially important. The pedals, steering wheel, instrument panel should be easily accessible and located in the places where the driver is used to seeing them.
Driver's seat
Adjust the seat as follows:
- Move the seat forward or backward so that you can freely press any pedal with a slightly bent leg.
- Position the seatback so that you can reach the top of the steering wheel with a slightly bent arm.
Caution: There must be no foreign objects in the driver's footwell. A foreign object at any time can get under the pedal and block it, which will not allow the driver, if necessary, to make the necessary maneuver or slow down the car.
Passenger seat
Adjust the seat as follows:
- Set the seat back upright.
- Move the seat forward or backward to accommodate the passenger's legs.
- Do not move the seat all the way back, otherwise it will become uncomfortable for the rear passenger.
1. Drawer 1 under the seats is used to store small things. Instead of a drawer, a CD player can be inserted under the passenger seat.
2. To move the seat forward or backward, lift the lever. 2. After moving the seat, release the lever and move the seat back and forth until the seat latch engages in the nearest slot.
3. Lever 3 is only on 2-door models. It serves to fold the back of the front seat when passing passengers to the rear seats. To organize the passage to the rear seats, lift the lever 3 and fold the backrest forward. After the passage of passengers, fold back.
4. Handwheel 4 adjusts the angle of the backrest. Do not tilt the backrest too far from the vertical, as in this position it is easy to slip out from under the seat belt.
5. To adjust the height of the seat cushion, swing the lever 5. To raise the cushion, swing the lever up from the base position, and to lower it, swing it down.
Cautions
Do not adjust the seat, especially the driver's seat, while driving. The seat may suddenly move and the driver will lose control of the vehicle controls.
When adjusting the longitudinal position of the seat, be careful not to hit the rear passenger seat or luggage.
After adjusting, try moving the seat back and forth to make sure it is securely locked.
After adjusting the seatback angle, try pressing the seatback backwards. Make sure it is securely fixed.
When adjusting the seat, keep your hands under the seat and keep them away from moving parts. Otherwise, you may injure your hand or fingers.
It is forbidden to remove and install airbags, make any changes to their wiring and seat heater wiring.
Seat head restraints
The headrests have two guide rods with slots for fixing the headrest in height. The rods slide in guide bushings. For your safety, adjust your head restraints before riding. Headrests are most effective when your head rests on them.
Cautions
Adjust the headrest so that the center of the headrest is at the top of your ears.
After adjusting the head restraint, make sure that it is securely locked in position.
Do not ride without a head restraint.
Head restraint height adjustment
To raise or lower the head restraint, grasp it with both hands and pull it up or down.
Removal and installation
To remove the head restraint, lift it up to the stop, press the button (shown by arrow) and pull out the headrest.
The rear head restraint can only be pulled out by tilting the seat back slightly forward.
To install the headrest, simply push it into the rails.
Visitor comments