Wheels and tires of car Volkswagen Beetle 1
General description of wheels and tires
Volkswagen Kafer vehicles are fitted as standard with 4 1/2 Jx15 rims and 5.60-15/6.00-15 or 155 SR 15 tires. All wheel discs are equipped with a flange, which is a comb pressed...
Volkswagen Kafer vehicles are fitted as standard with 4 1/2 Jx15 rims and 5.60-15/6.00-15 or 155 SR 15 tires. All wheel discs are equipped with a flange, which is a comb pressed...
Wheel balancing
Wheels are balanced at the factory. Balancing is necessary to eliminate uneven distribution of material and inaccuracies in wheel manufacturing. During the operation of the car,...
Wheels are balanced at the factory. Balancing is necessary to eliminate uneven distribution of material and inaccuracies in wheel manufacturing. During the operation of the car,...
Tire wear
Tires of correctly balanced wheels, while maintaining the prescribed pressure in them, with correct wheel geometry adjustment and serviceable shock absorbers, wear approximately...
Tires of correctly balanced wheels, while maintaining the prescribed pressure in them, with correct wheel geometry adjustment and serviceable shock absorbers, wear approximately...
Uneven tire wear
Uneven tire wear in most cases is due to too low or too high air pressure in them, and can also be the result of incorrect wheel alignment and balancing, poor condition of shock...
Uneven tire wear in most cases is due to too low or too high air pressure in them, and can also be the result of incorrect wheel alignment and balancing, poor condition of shock...
Wheel replacement
It is not recommended to change wheels unnecessarily, because. with their frequent removal and installation (the latter is usually done in practice without a torque wrench and...
It is not recommended to change wheels unnecessarily, because. with their frequent removal and installation (the latter is usually done in practice without a torque wrench and...
Geometric parameters of wheel installation
Optimum driving performance and minimum tire wear can only be achieved by properly fitting the wheels. With abnormal tire wear and poor vehicle stability on the road (poor...
Optimum driving performance and minimum tire wear can only be achieved by properly fitting the wheels. With abnormal tire wear and poor vehicle stability on the road (poor...
Checking and adjusting the camber of the front wheels (torsion bar suspension)
Examination Set wheels straight. Attach a goniometer to the wheel disk, mark with chalk the place of application of the device. Install the device so that the air bubble is in the...
Examination Set wheels straight. Attach a goniometer to the wheel disk, mark with chalk the place of application of the device. Install the device so that the air bubble is in the...
Adjustment of a convergence of forward wheels
Set the roller steering mechanism to the middle position. The marking ring on the steering shaft must be aligned with the edge of the steering gear housing. Mount the toe-in gauge...
Set the roller steering mechanism to the middle position. The marking ring on the steering shaft must be aligned with the edge of the steering gear housing. Mount the toe-in gauge...
Rear camber adjustment (rear axle with independent suspension)
The convergence of the rear wheels can be changed by shifting the axle housing in the longitudinal holes of the elastic lever. This will require a special tool. Install the camber...
The convergence of the rear wheels can be changed by shifting the axle housing in the longitudinal holes of the elastic lever. This will require a special tool. Install the camber...
Front camber adjustment (suspension with shock absorbers)
The front camber can be adjusted individually for each wheel by turning the eccentric bolts on the rocker arm. The oscillating arm mounted in the silent block can then be moved to...
The front camber can be adjusted individually for each wheel by turning the eccentric bolts on the rocker arm. The oscillating arm mounted in the silent block can then be moved to...
Adjustment of a convergence of forward wheels (suspension with shock absorbers)
Park the vehicle on a level, level surface. Set the front wheels straight. Install the front wheel toe-in gauge on the edge of the wheel disk at the height of its center. Set the...
Park the vehicle on a level, level surface. Set the front wheels straight. Install the front wheel toe-in gauge on the edge of the wheel disk at the height of its center. Set the...
Setting values for toe and camber angles
Note. The data given in the table refer to all vehicle variants when unladen. Instruction. 10 minutes of arc corresponds to a wheel toe of 1.2 mm (for 15" tires). Front suspension...
Note. The data given in the table refer to all vehicle variants when unladen. Instruction. 10 minutes of arc corresponds to a wheel toe of 1.2 mm (for 15" tires). Front suspension...
Abnormal tire wear
sign Cause Increased tire wear on both sides of the tread Tire pressure too low , Increased tire wear in the middle of the tread over the entire surface Too high tire pressure...
sign Cause Increased tire wear on both sides of the tread Tire pressure too low , Increased tire wear in the middle of the tread over the entire surface Too high tire pressure...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Caddy 3
Beetle
- General information
- User manual
- Daily care
- Maintenance
- Petrol engines 1.4 l
- Engine repair
- Cooling and lubrication system
- Power and exhaust system
- Petrol engines 1.6 l
- Engine repair
- Cooling and lubrication system
- Power and exhaust system
- Diesel engines
- Engine repair
- Cooling and lubrication system
- Power and exhaust system
- Transmission
- Mechanical gearbox 0AH
- Mechanical gearbox 0A4
- Drive shafts
- Chassis
- Car suspension
- Steering
- Brake system
- Body and wiring diagrams
- Interior and exterior
- Electrical circuits
- General information
- Maintenance
- Power unit
- Engine repair
- Cooling and lubrication system
- Supply system
- Exhaust system
- Transmission
- Clutch
- Car gearbox
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Wheels and tires
- Body
- Exterior
- Electrical equipment
- Equipment and devices
- Power devices
- Electrical circuits
VWmanual.ru © 2016-2024 | Mobile version | News and articles | Sitemap: EN BG BY UA RS HR RO PL SK HU | Write message | Site search
Passat B2 • Passat B3 • Passat B4 • Passat B5 • Passat B6 • Golf 1, diesel • Golf 1, petrol • Golf 2, petrol • Golf 2 • Golf 3 • Golf 4 • Golf 5 • Polo 3 • Polo 4 • Touareg 1 • Tiguan 1 • Sharan 1 • Transporter T3 • Transporter T4 • Beetle • Caddy 3 •
Passat B2 • Passat B3 • Passat B4 • Passat B5 • Passat B6 • Golf 1, diesel • Golf 1, petrol • Golf 2, petrol • Golf 2 • Golf 3 • Golf 4 • Golf 5 • Polo 3 • Polo 4 • Touareg 1 • Tiguan 1 • Sharan 1 • Transporter T3 • Transporter T4 • Beetle • Caddy 3 •