Description of the design of the gearbox The gearbox together with the main gear form a single whole. The unit can only be removed after the engine has been removed. As a rule, the removal of the gearbox is only...
Replacing the front rubber-metal support Replacing the front rubber-metal support can be done with the engine installed with a gearbox. Raise the rear of the vehicle and place it on stands. Loosen the nuts (see arrows)....
Replacement of protective covers of semiaxes In case of damage to the protective covers of the axle shafts, the gearbox can not be removed, since split covers are available as a spare part. Removing Raise the rear of the...
Replacement of epiploons in covers of bearings of semiaxes Oil seals can be replaced with the gearbox installed. Removing Remove the wheel cap, pull the cotter pin out of the axle shaft, loosen the castle nut. Attention! To avoid personal...
Removal and installation of the gear lever Gear change mechanism. 1 - gear lever (adjust); 2-20 Nm (2.0 kgcm); 3 - switching support (oblong hole should be directed with the pointed side forward); 4 - thrust plate (adjust...
Removal and installation of a mobile bar Removing Raise the vehicle and place it on stands. Remove the shift lever. Remove the rear seat and the mounting hole cover of the tie rod connector on the frame channel. Cut and...
Adjustment of the mechanism of a gear change Remove the cover from the switch support. Engage 2nd gear and loosen the bolts on the shift support. Attention! When carrying out the following work, the engine and gearbox must...