Warning indicator lights

Light indicators differ in priority (see fig. 3).

Priority 1 indicator lights are red.

Priority 2 indicator lights are yellow.

Priority 1 warning examples (Red)

Symbol Text: «STOP! BREMSFLUS-SIGKEIT BETRIEBSANLEITUNG» (STOP! BRAKE FLUID. MANUAL)

Symbol Text: «STOP! KUHLMITTEL PRUFEN. BETRIEBSANLEITUNG» (STOP! CHECK COOLANT LEVEL. MANUAL)

Symbol Text; «STOP! OLDRUCK MOTOR AUS! BETRIEBSANLEITUNG» (STOP! OIL PRESSURE DROP IN THE ENGINE! MANUAL)

When one of these faults occurs, the corresponding indicator light is on, the corresponding text appears on the MFD, and three consecutive beeps sound.


In this case, you need to stop as soon as possible, turn off the engine, check the relevant system and eliminate the malfunction.

If several priority 1 faults occur, the symbols appear in sequence for 2 seconds each, replacing each other.

If a priority 1 fault text message is present, no other MFD menus will function.

Priority 2 warning examples (yellow color)

Symbol Text: «OLSTAND PRUFEN» (OIL LEVEL). Check the condition of the engine oil as soon as possible and add the required amount.

Symbol Text: «WITTE TANKEN!» (ADD FUEL!). Add fuel.

Symbol Text: «WASCH WASSER AUFFCLLEN» (ADD WATER to WASHER). Add water and glass washer.

Symbol Text: «BREMSBELAG PRUFEN» (CHECK BRAKE SHOE LININGS). Check.

Symbol Text: «WEGFAHRSP. AKTIV». Appears when the car is locked in case of using a non-legalized copy of the key.

For any of these faults, the symbol lights up and an audible signal sounds. Check the corresponding function as soon as possible.


If several priority 2 faults occur, the characters appear in sequence for 2 seconds each, replacing each other.

After some time, the text is deleted and the symbol is shown on the edge of the display as a reminder.

Priority 2 warnings are only shown if no priority 1 warning is activated!