List of parts of the lubrication system with technological notes on repair to Figure VC2.194:
1. O-ring:
- move up to the shoulder;
- Applies to BGU engines only.
2. Connecting tube:
- Applies to BGU engines only.
3. Direction to the oil filler vent:
- Applies to BGU engines only.
4. Spring clamp:
- Applies to BGU engines only.
5. Mounting bracket:
- Applies to BGU engines only.
6. Screw plug: 15 Nm.
7. O-ring.
8. Oil pressure sensor (F1) 0.14 MPa (1.4 bar); 25 Nm:
- black color.
9. O-ring.
10. Oil filter bracket with pressed check valve.
11. Oil filter bracket screw: 15 Nm and tighten 1/4 turn (90°):
- when assembling, replace with a new one.
12. Gasket:
- when assembling, replace with a new one;
- snap into the heat exchanger clamps.
13. Heat exchanger:
- apply a thin layer of sealant to the mating surfaces to the oil filter bracket (except for the o-ring).
14. O-ring.
15. Oil filter:
- remove with a clamp or a key for oil filters;
- tighten by hand.
16. Screw plug: 40 Nm:
- when assembling, replace with a new one.
17. O-ring is non-removable.
18. Pressure reducing valve spring 0.4 MPa (4 bars).
19. Reducing valve piston.
20. Gasket:
- when assembling, replace with a new one.
Visitor comments