Instructions: The drawings show the right side of the car. On the left, work is carried out in a similar way.
- 1 - Mirror holder
- 2 - Mirror housing, material - ABS plastic
- 3 - Frame
- 4 - Bolt, 2 pcs., 1 Nm
- 5 - Overlay of the mirror housing with a repeater of the direction indicator
- 6 - Mirror element
- 7 - Soundproofing element, is an integral part of the mirror holder
Removal and installation of a mirror
Instructions: The process of removal and installation is described only for the right mirror. The left mirror is removed and installed in the same way. Work must be carried out with protective goggles and gloves!
Protect edges of body paintwork -3- from damage by covering them with fabric adhesive tape. Press lower part of mirror -1- into housing -3-. Lever out mirror reflector -1- with spudger -80-200- and press off bracket -4- and housing -3-arrow a-. Swing mirror element -1- to one side -arrow b- and disconnect contacts -2-.
Installation
Connect the contact to the mirror element. Insert the mirror element into the housing in the center of the bracket. The mirror element should lock into place with a distinct click. In conclusion, check the functioning of the mirror.
Removal and installation of an external rear-view mirror
Instructions: Below is a description of the removal and installation of the left rear-view mirror. The right mirror is removed and installed in the same way.
Remove the front door trim on the driver's side. Disconnect connector -4- for mirror wiring harness. Remove screw -2-. Pull mirror slightly in direction -arrow a- and remove from door window guide -5- arrow c-. Remove mirror -1- and feed cable -3- through hole in door.
Visitor comments