Glass section of the hatch
Instruction: In the absence of power supply, the front section of the sunroof can be moved by rotating the drive motor using an ordinary hex wrench. The front section can be moved manually until its front edge is flush with the front edge of the rear section. If you continue to move the section to the rear, the cables may jump out of the fasteners.
Remove the cover and front control panel.
Vehicles with interior monitoring system
Instructions: On vehicles with interior monitoring, a flat cable is fixed to the crossbar in the niche for the lampshade. To implement the emergency drive, you must carefully release the fastening of the flat cable.
Carefully release flat cable -5- from crossbar -1-. Move flat cable to one side -arrow- until a standard hexagon wrench -4- can be inserted into the hole in the crossbar -3-.
All
Insert the hexagon wrench -4- through the hole in the crossbar -1- and insert it into the hole of the bolt -3- of the engine -2-. When turning by hand, a lot of effort is required because the motor remains connected to the drive.
Sunblind
Instruction: In the event of a power failure, the sunroof sunshade can be moved manually using a conventional hex wrench.
Remove ceiling lining. Insert the hexagon wrench -2- into the hole of the blind motor bolt -1-. When turning by hand, a lot of effort is required because the motor remains connected to the drive.
Visitor comments