Linings, casings and decorative shields

Removal and installation of facing of space for legs

Instructions: The following describes the removal and installation work on the left side of the car Removal and installation on the right side is carried out in the same way.

Unclip plug -1- from trim using a small screwdriver. Remove screw -2- (1.5 Nm). Remove trim -3- in left footwell.

Removal and installation of the rear panel of the center console

Instructions: The following describes the work on removing and installing the panel with a cup holder. On vehicles with multimedia system or inverter with 12 V-230 V socket -U13-, removal and installation is carried out in the same way. Switch off the ignition.

Cars with a multimedia system

Remove the multimedia system control panel.

Vehicles with inverter with socket, 12 V-230 V -U13-

Remove inverter with socket, 12 V-230 V -U13-.

Cars with a cup holder

Open cup holder -1- and remove two screws -2- (1.5 Nm).



Unclip panel -1- at bottom -arrow A-. Detach panel at top from center console -arrow B-. Disconnect the wiring harnesses from the panel.

Removal and installation of an overlay of the central console

With manual transmission

Carefully remove seal -1- with frame -2- towards top.



Remove soundproof cover for selector mechanism -1- from center console.

With automatic transmission

Carefully pull collar -1- out of selector lever cover -2- towards top.




Detach selector cover -1-. Detach wiring harness -2- from selector lever cover.

All

Remove two screws -1- and -2- (1.5 Nm).



Detach rear section of trim -1- from center console upwards and detach existing (depending on configuration) wire harnesses.