- 1 - ABS control unit -J104-, installation location: on the hydraulic unit in the engine compartment on the left under the battery. Do not disconnect the connector before performing self-diagnosis. Switch off the ignition before disconnecting the connector. Do not disconnect from ABS valve body -N55-
- 2 - ABS hydraulic unit -N55-, installation location: in the engine compartment on the left under the battery. The hydraulic unit comprises the following components: Brake pressure sender -3201-. ABS hydraulic pump -V64-, valve block (contains intake and exhaust valves). The ABS hydraulic pump -V64- and the valve block are one piece. Do not disconnect from ABS control unit -J104-
- 3 - Brake pad wear warning light -K32-, installation location: in dash panel insert
- 4 - ABS warning lamp -K47-, installation location: in dash panel insert
- 5 - ESP and ASR warning lamp -K155-, installation location: in dash panel insert
- 6 - Brake system warning lamp -K118-, installation location: in dash panel insert
- 7 - Stop light switch -F-, installation location: brake master cylinder
- 8 - ASR and ESP deactivation button -E256-, installation location: in the center console
- 9 - ESP sensor unit -G419- and electromechanical parking brake control unit -J540-, installation location: under center console. The lateral acceleration sender -G200-, the yaw rate sender -G202- and the longitudinal acceleration sender -G251- are built into a single housing together with the electromechanical parking brake control unit -J540-
- 10 - Diagnostic connector, installation location: trim near the driver's feet
- 11 - Steering angle sender -G85-, fitting location: on steering column between steering wheel and steering column switch box
- 12 - Swivel fist
- 13 - Speed sender, front right/left -G45-/-G47-
- 14 - Wheel hub with bearing (bearing unit), the magnetic ring for the operation of the ABS sensor is built-in and the bearing
- 15 - Wheel bearing housing (drawing for all-wheel drive)
- 16 - Speed sender, rear right/left -G44-/-G46-
- 17 - Wheel hub with bearing (bearing unit) (drawing for all-wheel drive), the magnetic ring for ABS sensor operation is built into the bearing
Visitor comments