- 1 - Shock absorber
- 2 - Allen screw, end of screw must point in direction of travel, replace after each removal
- 3 - Front left speed sender -G47-, front right speed sender -G45- can be checked in Guided Fault Finding with the - Vehicle diagnosis, measuring and information system VAS 5051. Before installing the speed sender, clean the hole and apply a little grease -G 000 650-
- 4 - Hex socket bolt, M6x16, 8 Nm
- 5 - Tie rod end
- 6 - Wheel hub with bearing (bearing assembly), the magnetic ring for the operation of the ABS sensor is built into the wheel hub, various designs
- 7 - Nut, M12x1.5, 50 Nm, self-locking, replace after each removal
- 8 - Brake disc, ventilated
- 9 - Bolt, 70 Nm and tighten by 90°, replace after each removal, when loosening and tightening the bolts, the car must not be on wheels
- 10 - Bolt
- 11 - Bolt, M6x12, 12 Nm
- 12 - Shield
- 13 - Steering knuckle with screw-on brake caliper, after replacing the steering knuckle, it is necessary to check the wheel alignment
- 14 - Allen screw, M12x1.5x45, 70 Nm and tighten by 90°, replace after each removal
- 15 - Drive shaft
- 16 - Nut, M12x1.5x80, 70 Nm and tighten by 90°, self-locking, replace after each removal
Visitor comments