Detach wishbone from ball joint and respectively from steering knuckle. Fix the position of the support bracket. Replace bolt -1- on left side and -2- on right side with clamps -T10096- and tighten to 20 Nm.
Note: Locking pins -T10096- must be tightened to a maximum torque of 20 Nm, otherwise the threads may be damaged.
Now you need to unscrew the bolts -11- on the left side of the car and -12- on the right side of the car.
Unscrew bolts -1-. Remove the wishbone assembly with support bracket.
Installation
Insert the triangular lever together with the support bracket into the subframe. Screw in bolts -11- and -12- but do not tighten. Screw in and tighten bolts -1-. Retainer -T10096- must now be replaced with a new bolt and tightened down. Bolt triangular link to ball joint -arrows-. After setting the suspension to the position corresponding to the curb weight of the vehicle, tighten the bolts -11- and -12- securing the wishbone to the subframe. Further installation is carried out in the reverse order. Install the lower soundproof casing.
Instructions: Check the boot for damage and creases.
Tightening torques
| Support bracket for body. Use only new bolts | 70 Nm and tighten by 180° |
| Ball joint to triangular lever. Use only new nuts | 60 Nm |
| Wishbone to subframe. Use only a new bolt, tighten the bolt only in the position corresponding to the curb weight | 70 Nm and tighten by 180° |
Visitor comments